Welcome to the official RepRapFirmware Configuration Tool

Please follow this wizard to obtain an individual configuration bundle for your printer

If you are using a printer that was originally shipped with RepRapFirmware, you can select a predefined template here:

The following templates were contributed by users and have not been throughly tested:

Alternatively you can create your own individual configuration by creating a new one from scratch or by loading an existing JSON template:

General preferences
Printer geometry
mm
mm
mm
mm
mm
mm

This machine uses individual motors to drives each axis

This machine uses two coupled motors to position the nozzle on the XY plane

This machine uses two coupled motors to position the nozzle on the XZ plane

This machine uses two coupled motors to position the nozzle on the YZ plane

mm
mm
mm
mm
mm
mm

This machine uses towers to position the nozzle

Axis Direction Microstepping Steps per mm Max. instantaneous speed change Maximum speed Acceleration Motor current Motor driver
X
mm⁻¹
mm/s
mm/s
mm/s²
mA
Y
mm⁻¹
mm/s
mm/s
mm/s²
mA
Z
mm⁻¹
mm/s
mm/s
mm/s²
mA
Extruders
Drive Direction Microstepping Steps per mm Max. instantaneous speed change Maximum speed Acceleration Motor current Motor driver
E0
mm⁻¹
mm/s
mm/s
mm/s²
mA
Motor current reduction
%
s
Endstop configuration
Axis Endstop type Endstop location
X
Y
Z
Homing preferences
mm/s
mm/s
mm/s
mm
Z-Probe
mm
mm
mm/s
mm
mm
mm

A switch is used to determine the distance between nozzle and bed

An umodulated Z-probe is used to determine the distance between nozzle and bed (without trigger signal)

A modulated Z-probe is used to determine the distance between nozzle and bed (with trigger signal)

An ultrasonic Z-probe is used to determine the distance between nozzle and bed

General heater settings
°C
Heater Type Output scale factor Series resistance Thermistor coefficients Sensor channel
Bed Heated bed
%
Ω
R25 Ω
β K
C
E0 Nozzle
%
Ω
R25 Ω
β K
C
Tool mapping
Tool number Assigned extruders Assigned heaters X offset Y offset Z offset Mixing ratio
Bed compensation
mm
mm
mm
mm
Probe point X coordinate Y coordinate Height correction
Grid Compensation
mm
mm
mm
mm
mm
Orthogonal axis compensation
Network settings
Cooling fans
Fan name Value Invert output Frequency Thermostatic control Monitored heaters Thermostatic mode trigger temperature
FAN0
%
Hz
None available
°C
FAN1
%
Hz
None available
°C
Miscellaneous
Full list of all available G-codes